- Mar 06, 2019
-
-
Troy Kisky authored
Signed-off-by:
Troy Kisky <troy.kisky@boundarydevices.com>
-
- Sep 21, 2018
-
-
Troy Kisky authored
Signed-off-by:
Troy Kisky <troy.kisky@boundarydevices.com>
-
- Aug 27, 2018
-
-
Troy Kisky authored
Signed-off-by:
Troy Kisky <troy.kisky@boundarydevices.com>
-
- Aug 07, 2018
-
-
Troy Kisky authored
ash: add poweroff command ash: fix some input gpios(CH_ON_RBL/SG_ON_RBL/DOOR_CLOSED ash: use nitrogen6x/clock.cfg ash: use nitrogen6x ddr-setup.cfg ash: remove micrel phy references(only atheros on this board) ash: add CONFIG_CMD_GPIO ash: set rgb_gpio_pads ash: TP86 becomes lvds backlight enable ash: explicit fbp_detect_i2c ash: default uart1 to rs232 ash: use 800mhz for memory ash: use boundary.h ash: GP_BSL_CB_ON_OFF high, TX23D200_18 default dispay ash: add CONFIG_VIDEO_SKIP_VERSION ash: GP_BSL_CB_ON_OFF default to low again ash: add EIM_EB2 for sd card power control ash: add CONFIG_SPI_FLASH_SPANSION ash: ash_defconfig add CONFIG_BLOCK_CACHE ash: use common code for eth init ash: eth.c now in common directory ash: move misc_init_r/do_kbd to common ash: move mmc_init/ dram_init/ overwrite_console/ common_board_init/ splash_screen_prepare/ board_cfb_skip to common ash: gpio3 is power off, don't redefine ash: add power_init_board because mdelay cannot be used in board_early_init_f ash: use common 800mhz_4x128mx16.cfg ash: rgb24 vs rgb66 panel have different backlight active levels ash: fixup dtb backlight levels ash: add CONFIG_SPI_FLASH_GIGADEVICE: to defconfigs ash: use common ddr script ash: port to v2018.07 Signed-off-by:
Troy Kisky <troy.kisky@boundarydevices.com> ash: update to v2017.01 ash: update to v2017.03 Signed-off-by:
Gary Bisson <gary.bisson@boundarydevices.com>
-