net: phy: realtek: fix enabling of the TX-delay for RTL8211F

The old logic always enabled the TX-delay when the phy-mode was set to
PHY_INTERFACE_MODE_RGMII. With this patch we enable the TX delay for
PHY_INTERFACE_MODE_RGMII_ID and PHY_INTERFACE_MODE_RGMII_TXID and
disable it for PHY_INTERFACE_MODE_RGMII.

Based on a similar change made in the Linux Realtek PHY driver
by Martin Blumenstingl <martin.blumenstingl@googlemail.com>.

Signed-off-by: Madalin Bucur <madalin.bucur@nxp.com>
Acked-by: Joe Hershberger <joe.hershberger@ni.com>
Acked-by: York Sun <york.sun@nxp.com>

drivers/net/phy/realtek.c

@@ -95,17 +95,21 @@ static int rtl8211f_config(struct phy_device *phydev)
 
 	phy_write(phydev, MDIO_DEVAD_NONE, MII_BMCR, BMCR_RESET);
 
-	if (phydev->interface == PHY_INTERFACE_MODE_RGMII) {
-		/* enable TXDLY */
 	phy_write(phydev, MDIO_DEVAD_NONE,
 		  MIIM_RTL8211F_PAGE_SELECT, 0xd08);
 	reg = phy_read(phydev, MDIO_DEVAD_NONE, 0x11);
+
+	/* enable TX-delay for rgmii-id and rgmii-txid, otherwise disable it */
+	if (phydev->interface == PHY_INTERFACE_MODE_RGMII_ID ||
+	    phydev->interface == PHY_INTERFACE_MODE_RGMII_TXID)
 		reg |= MIIM_RTL8211F_TX_DELAY;
+	else
+		reg &= ~MIIM_RTL8211F_TX_DELAY;
+
 	phy_write(phydev, MDIO_DEVAD_NONE, 0x11, reg);
 	/* restore to default page 0 */
 	phy_write(phydev, MDIO_DEVAD_NONE,
 		  MIIM_RTL8211F_PAGE_SELECT, 0x0);
-	}
 
 	/* Set green LED for Link, yellow LED for Active */
 	phy_write(phydev, MDIO_DEVAD_NONE,