With 64 kb uniform flash sector size the old value of 128 kB was
too small.

ethaddr is assigned). Initialization moved from miiphy_register() to
eth_initialize().

Based on initial patch for 4xx platform by Matthias Fuchs.

- Support for TQM8541/8555 boards added.
- Complete rework of TQM8540/8560 support.
- Common TQM85xx code now supports all current TQM85xx platforms
  (TQM8540/8541/8555/8560).
- DDR SDRAM size detection added.
- CAS latency default values can be overwritten by setting "serial#"
  to e.g. "ABC0001 casl=25" -> CAS latency 2.5 will be used.
  If problems are detected with this non default CAS latency,
  the defualt values will be used instead.
- FLASH size detection added.
- Moved FCC ethernet driver initialization behind TSEC driver init
  -> TSEC is first device.

Patch by Stefan Roese, 30 Nov 2005

Patch by Stefan Roese, 29 Nov 2005

Patch by John Otken, 23 Nov 2005

Patch by Stefan Roese, 27 Nov 2005

On PPC44x platforms, the startup message generated in "cpu.c" only
comprised the ppc type and revision but not additional informations
like speed etc. Those speed infos where printed in the board specific
code. This new implementation now prints all CPU infos in the common
cpu specific code. No board specific code is needed anymore and
therefore removed from all current 44x implementations.

Patch by Stefan Roese, 27 Nov 2005

The COPYING file was extended to make clear that these files can be
used in non-GPL code, too.

- Added onboard PPC440 DDR autodetection in cpu/ppc/sdram.c
- CFG_FLASH_QUIET_TEST added to use the common CFI driver
  for bank autodetection
Patch by Stefan Roese, 22 Nov 2005

which makes the environment compatible with the hush shell.
WARNING: Support for the old '$(...)' syntax will be
discontinued in a later version.

Patch by Stefan Roese, 15 Nov 2005

Patch by Stefan Roese, 15 Nov 2005

Added CONFIG_NET_MULTI for VOM405 board.
Added reset_phy() for VOM405 board.
Patch by Matthias Fuchs, 09 Nov 2005

Add support for error LED.
Patch by Matthias Fuchs, 07 Nov 2005

Patch by Stefan Roese, 07 Nov 2005

Patch by Stefan Roese, 07 Nov 2005

Patch by Stefan Roese, 05 Nov 2005

Patch by Stefan Roese, 03 Nov 2005

Patch by Stefan Roese, 01 Nov 2005

The multiplexed signals Ext IRQ0...3 have to be configured as IRQ,
because they default to GPIOx (440EP/GR).

Patch by Stefan Roese, 28 Oct 2005

Patch by Stefan Roese, 20 Oct 2005

Patch by Stefan Roese, 20 Oct 2005