net: ravb: Detect PHY correctly

The order of parameters passed to the phy_connect() was wrong.
Moreover, only PHY address 0 was used. Replace this with code
capable of detecting the PHY address.

Signed-off-by: Marek Vasut <marek.vasut+renesas@gmail.com>
Cc: Joe Hershberger <joe.hershberger@ni.com>
Cc: Nobuhiro Iwamatsu <iwamatsu@nigauri.org>
Acked-by: Joe Hershberger <joe.hershberger@ni.com>
Signed-off-by: Nobuhiro Iwamatsu <iwamatsu@nigauri.org>

drivers/net/ravb.c

@@ -298,13 +298,14 @@ static int ravb_phy_config(struct udevice *dev)
 	struct ravb_priv *eth = dev_get_priv(dev);
 	struct eth_pdata *pdata = dev_get_platdata(dev);
 	struct phy_device *phydev;
-	int reg;
+	int mask = 0xffffffff, reg;
 
-	phydev = phy_connect(eth->bus, pdata->phy_interface,
-			     dev, PHY_INTERFACE_MODE_RGMII_ID);
+	phydev = phy_find_by_mask(eth->bus, mask, pdata->phy_interface);
 	if (!phydev)
 		return -ENODEV;
 
+	phy_connect_dev(phydev, dev);
+
 	eth->phydev = phydev;
 
 	/* 10BASE is not supported for Ethernet AVB MAC */