sf: Add bank address register writing support

This patch provides support to program a flash bank address
register.

extended/bank address register contains an information to access
the 4th byte addressing in 3-byte address mode.

reff' the spec for more details about bank addr register
in Page-63, Table 8.16
http://www.spansion.com/Support/Datasheets/S25FL128S_256S_00.pdf



Signed-off-by: Jagannadha Sutradharudu Teki <jaganna@xilinx.com>
Reviewed-by: Simon Glass <sjg@chromium.org>

drivers/mtd/spi/spi_flash.c

@@ -278,6 +278,32 @@ int spi_flash_cmd_write_status(struct spi_flash *flash, u8 sr)
 	return 0;
 }
 
+int spi_flash_cmd_bankaddr_write(struct spi_flash *flash, u8 bank_sel)
+{
+	u8 cmd;
+	int ret;
+
+	ret = spi_flash_cmd_write_enable(flash);
+	if (ret < 0) {
+		debug("SF: enabling write failed\n");
+		return ret;
+	}
+
+	ret = spi_flash_cmd_write(flash->spi, &cmd, 1, &bank_sel, 1);
+	if (ret) {
+		debug("SF: fail to write bank addr register\n");
+		return ret;
+	}
+
+	ret = spi_flash_cmd_wait_ready(flash, SPI_FLASH_PROG_TIMEOUT);
+	if (ret < 0) {
+		debug("SF: write bank addr register timed out\n");
+		return ret;
+	}
+
+	return 0;
+}
+
 #ifdef CONFIG_OF_CONTROL
 int spi_flash_decode_fdt(const void *blob, struct spi_flash *flash)
 {

drivers/mtd/spi/spi_flash_internal.h

@@ -77,6 +77,9 @@ static inline int spi_flash_cmd_write_disable(struct spi_flash *flash)
 /* Program the status register. */
 int spi_flash_cmd_write_status(struct spi_flash *flash, u8 sr);
 
+/* Program the bank address register */
+int spi_flash_cmd_bankaddr_write(struct spi_flash *flash, u8 bank_sel);
+
 /*
  * Same as spi_flash_cmd_read() except it also claims/releases the SPI
  * bus. Used as common part of the ->read() operation.