ARM: tegra: add common (shared) CPU files

These files are used by both SPL and main U-Boot.

Signed-off-by: Tom Warren <twarren@nvidia.com>
Signed-off-by: Stephen Warren <swarren@nvidia.com>
Tested-by: Thierry Reding <treding@nvidia.com>
Signed-off-by: Tom Warren <twarren@nvidia.com>

arch/arm/cpu/tegra-common/ap.c

 /*
-* (C) Copyright 2010-2011
+* (C) Copyright 2010-2014
 * NVIDIA Corporation <www.nvidia.com>
 *
  * SPDX-License-Identifier:	GPL-2.0+
@@ -27,7 +27,7 @@ int tegra_get_chip(void)
 	/*
 	 * This is undocumented, Chip ID is bits 15:8 of the register
 	 * APB_MISC + 0x804, and has value 0x20 for Tegra20, 0x30 for
-	 * Tegra30, and 0x35 for T114.
+	 * Tegra30, 0x35 for T114, and 0x40 for Tegra124.
 	 */
 	rev = (readl(&gp->hidrev) & HIDREV_CHIPID_MASK) >> HIDREV_CHIPID_SHIFT;
 	debug("%s: CHIPID is 0x%02X\n", __func__, rev);
@@ -84,7 +84,15 @@ int tegra_get_chip_sku(void)
 			return TEGRA_SOC_T114;
 		}
 		break;
+	case CHIPID_TEGRA124:
+		switch (sku_id) {
+		case SKU_ID_T124_ENG:
+		default:
+			return TEGRA_SOC_T124;
+		}
+		break;
 	}
+
 	/* unknown chip/sku id */
 	printf("%s: ERROR: UNKNOWN CHIP/SKU ID COMBO (0x%02X/0x%02X)\n",
 		__func__, chip_id, sku_id);
@@ -119,8 +127,8 @@ static u32 get_odmdata(void)
 	 * ODMDATA is stored in the BCT in IRAM by the BootROM.
 	 * The BCT start and size are stored in the BIT in IRAM.
 	 * Read the data @ bct_start + (bct_size - 12). This works
-	 * on T20 and T30 BCTs, which are locked down. If this changes
-	 * in new chips (T114, etc.), we can revisit this algorithm.
+	 * on BCTs for currently supported SoCs, which are locked down.
+	 * If this changes in new chips, we can revisit this algorithm.
 	 */
 
 	u32 bct_start, odmdata;

arch/arm/cpu/tegra-common/board.c

 /*
- *  (C) Copyright 2010,2011
+ *  (C) Copyright 2010-2014
  *  NVIDIA Corporation <www.nvidia.com>
  *
  * SPDX-License-Identifier:	GPL-2.0+
@@ -109,12 +109,18 @@ static int uart_configs[] = {
 	-1,
 	-1,
 	-1,
-#else	/* Tegra114 */
+#elif defined(CONFIG_TEGRA114)
 	-1,
 	-1,
 	-1,
 	FUNCMUX_UART4_GMI,	/* UARTD */
 	-1,
+#else	/* Tegra124 */
+	FUNCMUX_UART1_KBC,	/* UARTA */
+	-1,
+	-1,
+	FUNCMUX_UART4_GPIO,	/* UARTD */
+	-1,
 #endif
 };
 

arch/arm/cpu/tegra-common/cache.c

 /*
- * Copyright (c) 2013, NVIDIA CORPORATION.  All rights reserved.
+ * Copyright (c) 2013-2014, NVIDIA CORPORATION.  All rights reserved.
  *
  * This program is free software; you can redistribute it and/or modify it
  * under the terms and conditions of the GNU General Public License,
@@ -23,8 +23,6 @@
 
 void config_cache(void)
 {
-	struct apb_misc_gp_ctlr *gp =
-		(struct apb_misc_gp_ctlr *)NV_PA_APB_MISC_GP_BASE;
 	u32 reg = 0;
 
 	/* enable SMP mode and FW for CPU0, by writing to Auxiliary Ctl reg */
@@ -33,10 +31,10 @@ void config_cache(void)
 		"orr r0, r0, #0x41\n"
 		"mcr p15, 0, r0, c1, c0, 1\n");
 
-	/* Currently, only T114 needs this L2 cache change to boot Linux */
-	reg = (readl(&gp->hidrev) & HIDREV_CHIPID_MASK);
-	if (reg != (CHIPID_TEGRA114 << HIDREV_CHIPID_SHIFT))
+	/* Currently, only Tegra114+ needs this L2 cache change to boot Linux */
+	if (tegra_get_chip() < CHIPID_TEGRA114)
 		return;
+
 	/*
 	 * Systems with an architectural L2 cache must not use the PL310.
 	 * Config L2CTLR here for a data RAM latency of 3 cycles.