Select Git revision
clk_stm32f.c
Forked from
Reform / reform-boundary-uboot
Source project has a limited visibility.
-
Patrice Chotard authored
Move SYSCFG clock setup into configure_clocks() instead of calling clock_setup() from board file. As this clock is only needed in case of ethernet enabled and as both stm32f4 and stm32f7 are using the Designware ethernet IP, we use CONFIG_ETH_DESIGNWARE to only enable this clock if needed. Move the RMII setup from board_early_init_f() to board_init() to insure that RMII bit is set only when clock driver is initialized. Signed-off-by:
Patrice Chotard <patrice.chotard@st.com>
Patrice Chotard authoredMove SYSCFG clock setup into configure_clocks() instead of calling clock_setup() from board file. As this clock is only needed in case of ethernet enabled and as both stm32f4 and stm32f7 are using the Designware ethernet IP, we use CONFIG_ETH_DESIGNWARE to only enable this clock if needed. Move the RMII setup from board_early_init_f() to board_init() to insure that RMII bit is set only when clock driver is initialized. Signed-off-by:
Patrice Chotard <patrice.chotard@st.com>