quark.c

/*
 * Copyright (C) 2015, Bin Meng <bmeng.cn@gmail.com>
 *
 * SPDX-License-Identifier:	GPL-2.0+
 */

#include <common.h>
#include <mmc.h>
#include <netdev.h>
#include <phy.h>
#include <asm/io.h>
#include <asm/irq.h>
#include <asm/pci.h>
#include <asm/post.h>
#include <asm/processor.h>
#include <asm/arch/device.h>
#include <asm/arch/msg_port.h>
#include <asm/arch/quark.h>

static struct pci_device_id mmc_supported[] = {
	{ PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_QRK_SDIO },
};

/*
 * TODO:
 *
 * This whole routine should be removed until we fully convert the ICH SPI
 * driver to DM and make use of DT to pass the bios control register offset
 */
static void unprotect_spi_flash(void)
{
	u32 bc;

	bc = x86_pci_read_config32(QUARK_LEGACY_BRIDGE, 0xd8);
	bc |= 0x1;	/* unprotect the flash */
	x86_pci_write_config32(QUARK_LEGACY_BRIDGE, 0xd8, bc);
}

static void quark_setup_bars(void)
{
	/* GPIO - D31:F0:R44h */
	pci_write_config_dword(QUARK_LEGACY_BRIDGE, LB_GBA,
			       CONFIG_GPIO_BASE | IO_BAR_EN);

	/* ACPI PM1 Block - D31:F0:R48h */
	pci_write_config_dword(QUARK_LEGACY_BRIDGE, LB_PM1BLK,
			       CONFIG_ACPI_PM1_BASE | IO_BAR_EN);

	/* GPE0 - D31:F0:R4Ch */
	pci_write_config_dword(QUARK_LEGACY_BRIDGE, LB_GPE0BLK,
			       CONFIG_ACPI_GPE0_BASE | IO_BAR_EN);

	/* WDT - D31:F0:R84h */
	pci_write_config_dword(QUARK_LEGACY_BRIDGE, LB_WDTBA,
			       CONFIG_WDT_BASE | IO_BAR_EN);

	/* RCBA - D31:F0:RF0h */
	pci_write_config_dword(QUARK_LEGACY_BRIDGE, LB_RCBA,
			       CONFIG_RCBA_BASE | MEM_BAR_EN);

	/* ACPI P Block - Msg Port 04:R70h */
	msg_port_write(MSG_PORT_RMU, PBLK_BA,
		       CONFIG_ACPI_PBLK_BASE | IO_BAR_EN);

	/* SPI DMA - Msg Port 04:R7Ah */
	msg_port_write(MSG_PORT_RMU, SPI_DMA_BA,
		       CONFIG_SPI_DMA_BASE | IO_BAR_EN);

	/* PCIe ECAM */
	msg_port_write(MSG_PORT_MEM_ARBITER, AEC_CTRL,
		       CONFIG_PCIE_ECAM_BASE | MEM_BAR_EN);
	msg_port_write(MSG_PORT_HOST_BRIDGE, HEC_REG,
		       CONFIG_PCIE_ECAM_BASE | MEM_BAR_EN);
}

static void quark_enable_legacy_seg(void)
{
	u32 hmisc2;

	hmisc2 = msg_port_read(MSG_PORT_HOST_BRIDGE, HMISC2);
	hmisc2 |= (HMISC2_SEGE | HMISC2_SEGF | HMISC2_SEGAB);
	msg_port_write(MSG_PORT_HOST_BRIDGE, HMISC2, hmisc2);
}

int arch_cpu_init(void)
{
	struct pci_controller *hose;
	int ret;

	post_code(POST_CPU_INIT);
#ifdef CONFIG_SYS_X86_TSC_TIMER
	timer_set_base(rdtsc());
#endif

	ret = x86_cpu_init_f();
	if (ret)
		return ret;

	ret = pci_early_init_hose(&hose);
	if (ret)
		return ret;

	/*
	 * Quark SoC has some non-standard BARs (excluding PCI standard BARs)
	 * which need be initialized with suggested values
	 */
	quark_setup_bars();

	/* Turn on legacy segments (A/B/E/F) decode to system RAM */
	quark_enable_legacy_seg();

	unprotect_spi_flash();

	return 0;
}

int print_cpuinfo(void)
{
	post_code(POST_CPU_INFO);
	return default_print_cpuinfo();
}

void reset_cpu(ulong addr)
{
	/* cold reset */
	x86_full_reset();
}

int cpu_mmc_init(bd_t *bis)
{
	return pci_mmc_init("Quark SDHCI", mmc_supported,
			    ARRAY_SIZE(mmc_supported));
}

int cpu_eth_init(bd_t *bis)
{
	u32 base;
	int ret0, ret1;

	pci_read_config_dword(QUARK_EMAC0, PCI_BASE_ADDRESS_0, &base);
	ret0 = designware_initialize(base, PHY_INTERFACE_MODE_RMII);

	pci_read_config_dword(QUARK_EMAC1, PCI_BASE_ADDRESS_0, &base);
	ret1 = designware_initialize(base, PHY_INTERFACE_MODE_RMII);

	if (ret0 < 0 && ret1 < 0)
		return -1;
	else
		return 0;
}

void cpu_irq_init(void)
{
	struct quark_rcba *rcba;
	u32 base;

	base = x86_pci_read_config32(QUARK_LEGACY_BRIDGE, LB_RCBA);
	base &= ~MEM_BAR_EN;
	rcba = (struct quark_rcba *)base;

	/*
	 * Route Quark PCI device interrupt pin to PIRQ
	 *
	 * Route device#23's INTA/B/C/D to PIRQA/B/C/D
	 * Route device#20,21's INTA/B/C/D to PIRQE/F/G/H
	 */
	writew(PIRQC, &rcba->rmu_ir);
	writew(PIRQA | (PIRQB << 4) | (PIRQC << 8) | (PIRQD << 12),
	       &rcba->d23_ir);
	writew(PIRQD, &rcba->core_ir);
	writew(PIRQE | (PIRQF << 4) | (PIRQG << 8) | (PIRQH << 12),
	       &rcba->d20d21_ir);
}

int arch_misc_init(void)
{
	return pirq_init();
}