Skip to content
Snippets Groups Projects
README.sh_qspi_test 1.28 KiB
Newer Older
  • Learn to ignore specific revisions
  • -------------------------------------------------
       Simple steps used to test the SH-QSPI at U-Boot
    -------------------------------------------------
    
    #0, Currently, SH-QSPI is used by lager board (Renesas ARM SoC R8A7790)
        and koelsch board (Renesas ARM SoC R8A7791). These boot from SPI ROM
        basically. Thus, U-Boot start, SH-QSPI will is operating normally.
    
    #1, build U-Boot and load u-boot.bin
    
      => tftpboot 40000000 u-boot.bin
      sh_eth Waiting for PHY auto negotiation to complete.. done
      sh_eth: 100Base/Half
      Using sh_eth device
      TFTP from server 192.168.169.1; our IP address is 192.168.169.79
      Filename 'u-boot.bin'.
      Load address: 0x40000000
      Loading: ############
        2.5 MiB/s
      done
      Bytes transferred = 175364 (2ad04 hex)
    
    #2, Commands to erase/write u-boot to flash device
    
      Note: This method is description of the lager board. If you want to use the
      other boards, please change the value according to each environment.
    
      =>  sf probe 0
      SF: Detected S25FL512S_256K with page size 512 Bytes, erase size 64 KiB, total 64 MiB
      => sf erase 80000 40000
      SF: 262144 bytes @ 0x80000 Erased: OK
      => sf write 40000000 80000 175364
      SF: 1528676 bytes @ 0x80000 Written: OK
      =>
    
    #3, Push reset button.
    
      If you're written correctly and driver works properly, U-Boot starts.